Installation Instructions

Muting or Activating the Warning Alarm

1. To mute …immediately after you turn the key on and the gauge powers up into self test mode … hold the set button in until the alarm stops.
2. To activate … immediately after you turn the key on and the gauge powers up into self test mode … hold the set button in until the alarm starts.

Setting the Warning Alarm

1. Hold the set button in for about five seconds … the gauge pointer starts flashing. Release the button.
2. Now within about 5 seconds push and hold the set button in again and the pointer will move clockwise in incremental steps up to the maximum and then start working its way back anticlockwise in increments all the way back. When the needle reaches your desired setting release the button.
3. Repeat the process if you wish to reset to a different setting.